| %pythoncode %{ | |
| # wiringPi modes | |
| WPI_MODE_PINS = 0; | |
| WPI_MODE_GPIO = 1; | |
| WPI_MODE_GPIO_SYS = 2; | |
| WPI_MODE_PHYS = 3; | |
| WPI_MODE_PIFACE = 4; | |
| WPI_MODE_UNINITIALISED = -1; | |
| # Pin modes | |
| INPUT = 0; | |
| OUTPUT = 1; | |
| INPUT_PULLUP = 2; | |
| INPUT_PULLDOWN = 3; | |
| PWM_OUTPUT = 4; | |
| GPIO_CLOCK = 5; | |
| SOFT_PWM_OUTPUT = 6; | |
| SOFT_TONE_OUTPUT = 7; | |
| PWM_TONE_OUTPUT = 8; | |
| LOW = 0; | |
| HIGH = 1; | |
| # Pull up/down/none | |
| PUD_OFF = 0; | |
| PUD_DOWN = 1; | |
| PUD_UP = 2; | |
| # Interrupt levels | |
| INT_EDGE_SETUP = 0; | |
| INT_EDGE_FALLING = 1; | |
| INT_EDGE_RISING = 2; | |
| INT_EDGE_BOTH = 3; | |
| # Shifting (from wiringShift.h) | |
| LSBFIRST = 0; | |
| MSBFIRST = 1; | |
| %} |